Filter
Top Products
- Eng 12 -
5. Memory recall
You can recall stored data by pressing the
“Memory” switch, except when performing a
measurement.
• Up to 99 sets of measurement results are auto-
matically stored in memory, and memory cell
No. 1 is always used to store the oldest set of
results.
• Press “Memory” switch, the memory cell num-
ber with the stored measurement results (Sys-
tolic / Diastolic and Pulse with Date/Time) are
displayed for 1 minute.
* Pressing “Memory” button, nothing will appear
on the display if there is no data in the memory.
• If the “Memory” switch is pressed further, the
old date are indicated in the order of the time
series.
• Press “Start/Stop” switch to turn off the unit.
6. Memory clear function
To clear memory data, take out the two batteries
at same time and then press the “START/STOP”
switch for a while. All memory is erased.
Press the “POWER/START” switch to turn off.
CAUTION
To discontinue a measurement for any reason,
press the “POWER/START” switch. This causes
the “wrist cuff” to deflate rapidly.