Filter
Top Products
- Eng 10 -
3. Turn Power OFF
Press the “POWER / START” switch to turn off.
4. Subsequent Measurement
When a measurement is need again, 10 minutes, interval
is necessary between measurements.
5. Automatic Power OFF Function
If the unit is left without any operation after measure-
ment, an “Automatic Power-OFF Function” runs to turn
off the power after approximately 3 minutes. To continue
measurement, press the “POWER / START” switch again.
6. Battery Replacement
If the batteries are almost empty, the “ ” mark will be
displayed. In this case, batteries should be replaced with
new one.
Remove the battery cover at mainframe and replace four
type “AA” batteries.
Batteries are almost empty.
Batteries are normal.
Note: The memory data are erased when you replace the
batteries.
• The batteries that are included power the monitor. They
may not last as long as indicated.
• If manganese batteries are used at a low room tempera-
ture, such as in the winter or for other reasons, the bat-
teries may not function properly and you may not be able
to measure your blood pressure.
• Please dispose of used batteries properly to protect the
environmental.
Battery cover