Filter
Top Products
SKU 42802 For technical questions, please call 1-800-444-3353. Page 5
PREPARATION
Setup an air supply with an air pres-1.
sure regulator and moisture trap (do
not use an inline air oiler). The air
compressor must provide an air pres-
sure of 20 to 40 PSI.
Select a safe location for spraying 2.
and curing with:
- adequate lighting
- active ventilation
- no ame or ignition source
- an area dry, clean, and covered --
free of ammable material
Have an activated charcoal lter 3.
respirator availability for use when
curing.
Have disposable dust masks avail-4.
able for use when powder spraying.
Have a pair of vinyl gloves for 5.
use when handling the power and
sprayed objects.
Use ANSI-approved safety glasses.6.
If using an extension cord, it must 7.
have a ground prong.
Setup a dedicated electric oven (8. with
adequate ventilation) for curing the
coated objects with a temperature
capability from 300 to 500° F.
WARNING: Never use a gas oven, the
fumes from curing can be explo-
sive. Never use a home oven that
is also used for food. Contamina-
tion of food will occur.
Clean the object to be powder coated 9.
of any old coatings, rust, grease and
oil.
OPERATION
Place or hang the cleaned object to 1.
be coated near the ventilation sys-
tem.
If the object has grooves or recesses,
position the object so that gravity as-
sists the powder mist to fall into the
grooves or recesses.
Connect the Disposable Moisture 2.
Separator (8) to the Spray Gun (2).
Connect Air Hose
Disposable Moisture Separator (8)
Pedal Switch (11)
Ground Clip (10)
Control Box (1)
Scatter Tip (12)
Regulating Screw (14)
MAIN COMPONENTS