Filter
Top Products
SKU 42802 For technical questions, please call 1-800-444-3353. Page 4
product, but must be supplied by the
operator.
Additional Safety Warnings for
the Powder Coating System
The powder dust is ammable 1.
when oating in the air.
- Ventilate the area well.
- Verify that there are no ames or
ignition source nearby.
- Control excess dust by cleaning up
after each use.
- Never vacuum up the dust using a
non-explosion proof vacuum cleaner.
- Never cure coated object in a gas
oven as the fumes recreated can be
ammable; only use an electric oven.
- Never smoke while using the Pow-
der Coating System.
Avoid electrical shock!2.
- Never touch the emitter (metal tip)
of the Spray Gun. After use (and
turned OFF), touch the emitter to the
Ground Clip to discharge it.
- Do not use the Spray Gun if you
carry and use any electronic medical
devices.
- Never touch the metal object during
coating.
Avoid powder contamination3. .
- Protect your lungs by using an ap-
proved dust mask.
- Never cure objects in an electric
oven that is used for food also.
- Ventilate the area well.
- Wear an activated charcoal respi-
rator when oven curing the coated
object.
Unpacking
When unpacking, check to make sure
the following parts are included (Refer to
the Parts List and Assembly Drawing at
the end of this manual):
- Spray Gun, - Foot Switch,
- Transformer, - In-line Filters,
- two Powder Cups - Ground Clip Cable
- three Scatter Tips
If any parts are missing or broken,
please call Harbor Freight Tools at the
number on the cover of this manual as
soon as possible.