Filter
Top Products
SKU 42802 For technical questions, please call 1-800-444-3353. Page 2
SPECIFICATIONS
Power Consumption 120 V~, 60 Hz
Air Supply 20 to 40 PSI, dry air
Air Inlet 1/4 inch NPT thread
Power Cord 16 AWG
Note: Performance of this tool may vary
depending on variations in local line
voltage. Extension cord usage may
also affect tool performance.
Save This Manual
You will need the manual for the safe-
ty warnings and precautions, assembly
instructions, operating and maintenance
procedures, parts list and diagram. Keep
your invoice with this manual. Write the
invoice number on the inside of the front
cover. Keep the manual and invoice in a
safe and dry place for future reference.
SAFETY WARNINGS AND
PRECAUTIONS
WARNING: When using tool, basic
safety precautions should always
be followed to reduce the risk of
personal injury and damage to
equipment.
Read all instructions before using this
tool!
Keep work area clean1. . Cluttered
areas invite injuries.
Observe work area conditions2. . Do
not use machines or power tools in
damp or wet locations. Don’t expose
to rain. Keep work area well lighted.
Do not use electrically powered tools
in the presence of ammable gases
or liquids.
Keep children away3. . Children must
never be allowed in the work area.
Do not let them handle machines,
tools, or extension cords.
Store idle equipment4. . When not
in use, tools must be stored in a dry
location to inhibit rust. Always lock
up tools and keep out of reach of
children.
Do not force tool5. . It will do the job
better and more safely at the rate for
which it was intended. Do not use
inappropriate attachments in an at-
tempt to exceed the tool capacity.
Use the right tool for the job6. . Do
not attempt to force a small tool or
attachment to do the work of a larger
industrial tool. There are certain
applications for which this tool was
designed. Do not modify this tool and
do not use this tool for a purpose for
which it was not intended.
Dress properly7. . Do not wear loose
clothing or jewelry as they can be
caught in moving parts. Protective,
electrically non-conductive clothes
and non-skid footwear are recom-
mended when working. Wear restric-
tive hair covering to contain long hair.
Use eye and ear protection8. . Always
wear ANSI approved impact safety
goggles. Wear a full face shield if you
are producing metal lings or wood
chips. Wear an ANSI approved dust
mask or respirator when working
around metal, wood, and chemical
dusts and mists.
Do not overreach9. . Keep proper
footing and balance at all times. Do
not reach over or across running
machines.
REV 09d