Filter
Top Products
9
6 To clean the tweezer element, use the
cleaning brush dipped into alcohol.
Turn the product around and clean the
tweezers with the brush while turning
the barrel manually.
7 Remove the epilation head by pressing
the release buttons on the left and
right and pull it off.
Give the top of the housing a quick
clean with the brush. Place the epilation
head and the massaging rollers back
on the housing.
B Shaving
1. Remove the OptiTrim attachment.
Put on the shaver head by clicking
it in (the long hair trimmer should be in
front).
2. When using the shaver head, always
slide the switch up to setting «2».
3. For best results, guide the shaving
system in a way that about half of the
shaving foil and the long hair trimmer
are in contact with your skin. Always
guide the appliance in the direction of
the trimmer. The trimmer first raises all
long hairs and cuts them off. Then the
flexible foil follows to smooth away
any stubble.
Pre-cuttin
g hair for epilation
4. If you choose to pre-cut your hair to
the ideal length for epilation, place the
OptiTrim attachment onto the shaver
head.
5. Hold the appliance with the OptiTrim
attachment ensuring that the surface
of the comb is lying flat on the skin.
Guide the appliance with the comb
tips against the hair growth as shown
in illustration B 5.
N.B. As hair does not always grow in
the same direction it may be difficult to
cut. In which case, guide the appliance
slightly diagonally or in different
directions.
Cleaning the shaver head
6. After shaving, unplug the appliance
and, if necessary, remove the OptiTrim
attachment.
7. Clean the OptiTrim attachment with
the brush.
8. In order to clean the shaver head,
remove the shaving foil frame .
To do so, press the release bars on
the front and back and pull it off.
9. Carefully tap the shaving foil frame on
a flat surface.
10. Brush out the cutter block as well
as the area below the cutter block.
11. N.B.: The shaving foil is a very delicate
part that must not be cleaned with the
brush.
12. We recommend that you put a drop of
light machine oil along the length of
the trimmer every 3 months.
13. Put the shaving foil frame back on and
snap it into place.
14. Replace the OptiTrim attachment be-
cause it also serves as a protective
cap.
Note:
Do not use the shaver head with a
damaged shaving foil.
Replacing the shaving parts
The shaving foil and the cutter block are
precision parts that wear out with the time.
Have the shaving foil frame and the cutter
block replaced when you notice a reduced
shaving performance even after cleaning
the shaver head.
Subject to change without notice.
This product conforms to the
European Directives EMC
2004/108/EC and Low Voltage
2006/95/EC
3
8a
8
8b
8c
8d
98779220_SE3280_S6-68 Seite 9 Mittwoch, 13. August 2008 1:34 13