Filter
Top Products
Page 8
2. Remove outer and inner control panel covers. Install the 3 pin accessory plug from
the parts bag into the control panel if not already equipped. See figure 7A for side
installation on the 5 or 6 ton cabinet size. See figure 7B for back installation on the 2
and 3 ton cabinet size.
3. Plug the WUVCLP light into the 3 pin accessory plug just installed. Plug located on
the side or back of the control panel.
460 Volt Three Phase Only
1. Remove the transformer cover and
set aside. Place the transformer
assembly on the left side of the
blower partition. Remove the back
screw holding the blower partition
to the side angle. Place the back
left corner of the transformer box
over this hole and reinstall screw.
Use an additional self-drilling screw
to secure the front right corner of
the transformer box. (See Figure
8)
2. Run the flexible conduit across the
back of the blower partition and
down through the blower partition
in the same opening that the
copper tubing goes through. Use
wire ties to secure the conduit to
the suction line. (See Figure 6B)
Figure 7A
Figure 7B
Figure 8
Install
1-480701-0
cap as shown
Install
1-480701-0
cap as shown