Filter
Top Products
Page 7
7. Slide the left bracket tight against the left
side of the unit. Insert two self drilling
screws on the left side of the unit and into
the left side mounting bracket of the
WUVCLP light assembly. Use the pilot
holes in the mounting brackets for
alignment. Tighten the ¼ in screw on the
left side bracket to hold in place. (See
Figure 5)
8. Unpack the WUVCLP light bulb and insert
the plug end through the hole closest to the
wire connection. Then insert the other end
of the bulb through the other end bracket.
When the bulb is in place use the clamp to
secure the bulb and connect the wire plug
to the light bulb.
9. Use the alcohol wipe to clean any oil or dirt
deposits off the UV light bulb. Oils from
human skin will reduce the effectiveness of
the UV light bulb
WIRING
230/208 Volt Single Phase and Three Phase Units Only
1. For 230/208 volt single phase and three phase units run the flexible conduit and
wires down through the blower partition in the same opening that the copper tubing
goes through. Use wire ties to secure the conduit to the suction line. See Figure 6A
& 6B.
Figure 5
Figure 6A
Figure 6B