Filter
Top Products
EQ MODES
Post EQ is for users who prefer using the EQ from their software. To to toggle the post EQ mode
on and off; before powering up the VMS4, press and hold the on the 4th channel
MIDILOG and then power "ON" the unit. Release the button, your computer may reinstall the VMS4
as a new device, please allow 10-20 seconds for the change to take place. Confirm the EQ change
by checking the ASIO Driver configuration. The first number in the sequence will be a "1" in this
mode. Please see the window below.
Make sure you are using software where you can map the MIDI from the EQ and that the EQ has
been mapped when using this mode.
©American Audio® - www.americanaudio.us - VMS4™ Instruction Manual Page 20