Filter
Top Products
©American Audio® - www.americanaudio.us - VMS4™ Instruction Manual Page 12
Press this button to PAUSE what ever music source is playing.
Press this button to PLAY your desired music source.
Pressing the button during playback immediately pauses playback and returns the
track to the last set cue point. The red CUE LED will glow when the unit is in cue mode. The LED will
also flash every time a new CUE POINT is set. The CUE button can be held down to momentarily play
the track. When you release the CUE button it instantly returns to the CUE POINT. You can also tap
the CUE button to create a BOP EFFECT.
This wheel has three functions;
Make sure that is touch or resting on the jog wheels when you power on the
VMS4.
The wheel works as a pitch bend during Playback. Turning the wheel clockwise can increase the
pitch percentage up to 100%, and turning the wheel in the counter-clockwise direction can de-
crease the pitch percentage down to -100%. The pitch bend will be determined on how long
you turn the jog wheel continuously.
The jog wheel also controls the scratch effect, when the scratch effect is active.
The jog wheel can also serve as frame search.
The inside of the wheel is touch sensitive and the outside edge of the wheel is not. Example:
You can scratch by touching the inside or center of the wheel, and pitch bend when you touch the
outside edge of the wheel.
Pushing this button activates VINYL mode.
Enables secondary MIDI command on buttons, jog wheel, and MIDI functions on mouse
pad. Example: Press SHIFT and VINYL to activate Keylock.
The (-) pitch bend function creates a momentary “Slow Down” in the
BPM’s (Beats per minute) while it is playing. This will allow you to match the beats between two play-
ing audio sources. Remember, this is a momentary function. When you remove your finger from the
pitch button, the BPM’s will automatically return to pitch value Holding down this
button will give a maximum of -100% pitch. Use this function to slow to another playing music source.
Be sure to notice that this function is a momentary pitch adjustment, for a more precise adjustment
use the to match the BPM’s with another playing music source.
The (+) pitch bend function creates a momentary “BUMP” in the
BPM’s (Beats per minute) while it is playing. This will allow you to match the beats between two play-
ing audio sources. Remember, this is a momentary function. When you remove your finger from this
button, the BPM’s will automatically return to theselected pitch. Holding down this
button will give a maximum of +100% pitch.
These buttons are used to store either four (4) cue points or four (4) samples.
Each Bank Button can store either a sample or a cue point.
This slider is used to adjust the playback pitch percentage. The slider is a set
adjustment and will remain set until the pitch slider is moved or the pitch function has been turned
off.
Use this button to set this deck to master and auto sync and the other deck's
tempo to master.
GENERAL FUNCTIONS AND CONTROLS (Cont.)