Filter
Top Products
Page 38 HV-WP/HW-WP Series
13. Simple Batch Function
Step 6 Press the MODE switch to display the blinking HI (of
the final value).
Step 7 Set the final value using the following switches.
∧ switch Selecting the number of a figure.
＜ switch Selecting a figure.
Step 8 Press the ENTER switch to store the new parameter
and display the blinking OK (of preliminary value).
Step 9 Set the preliminary value using the following switches.
∧ switch Selecting the number of a figure.
＜ switch Selecting a figure.
Step10 Press the ENTER switch to store the new parameter
and display the blinking LO (of zero band).
Step11 Set the zero band using the following switches.
∧ switch Selecting the number of a figure.
＜ switch Selecting a figure.
Step12 Press the ENTER switch to store the new parameter
and display the weighing mode.
13.2.
13.2.13.2.
13.2. Operation and Performance (Examples)
Operation and Performance (Examples)Operation and Performance (Examples)
Operation and Performance (Examples)
Step 1 Select the parameter f6 8 of the function table.
Step 2 Set the parameters of the final value, preliminary value and zero band.
Step 3 The comparison result is always displayed.