Filter
Top Products
12
Troubleshooting Tag Dispenser problems
The tag dispenser switch controls the motor
used to advance tags to the feeder opening on
the top of the Conversion Station.
The tag dispenser switch has three positions:
ON (up) position
OFF (middle) position
JOG (down) position
711-811_HG_005
Switch
Problem Solution
The motor stops before a
tag advances into the
correct position above the
tag feeder opening,
Turn the tag dispenser switch to the OFF (middle) position and then to the ON
(up) position. A tag should advance through the tag feeder opening and into
the correct position.
A tag jams below the
surface of the tag feeder
opening,
1 Go inside the Conversion Station cabinet and clear the jammed tag.
2 Turn the tag dispenser switch to the OFF (middle) position and then to the
ON (up) position.
A tag should advance through the tag feeder opening and into the correct
position.
A tag appears in or slightly
above the tag feeder
opening but you cannot
peel off the tag
Turn the tag dispenser switch to the JOG (down) position as many times as
necessary to advance or “jog” the tag into the correct position.