4 - 69
CHAS
FRONT FORK
11.Slowly stroke the inner tube 1 up and
down.
12.Before measuring the fork oil level, wait ten
minutes until the oil has settled and the air
bubbles have dispersed.
NOTE:
@
Be sure to bleed the front fork leg of any resid-
ual air.
13.Measure:
• front fork leg oil level a
Out of specification → Correct.
Front fork leg oil level (from the
top of the inner tube, with the
inner tube fully compressed, and
without the spring)
79 mm
14.Install:
• nut 1
• damper adjusting rod 2
• cap bolt 3
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Install the nut 1 and finger tighten it.
b. Install the damper adjusting rod 2.
c. Install the cap bolt 3 and finger tighten it.
WARNING
@
Always use a new cap bolt O-ring.
d. Hold the cap bolt and tighten the nut 1 to
specification.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
T
R
.
.
Nut
25 Nm (2.5 m · kg)
15.Install:
• cap bolt
(to the outer tube)
NOTE:
@
• Before installing the cap bolt, lubricate its O-
ring with grease.
• Temporarily tighten the cap bolt.
