THERMOSALD ISC – MANUAL QUICK START Rev. 2005 / 03
Manual cod.: 3ES080x_Vx_QS_EN Page Nr. 2 Tot. Nr . 2
0 WARNINGS
THIS BOOK IS SUPPLIED WITH OUR PRODUCT AND DESCRIBES THE FUNDAMENTAL FUNCTIONS
EMPLOY QUALIFIED AND WELL-TRAINED PERSONNEL, FAMILIAR WITH THE TECHNOLOGY USED TO INSTALL
OR MAINTENANCE THE EQUIPMENT, CONSULTING MAINTENANCE & OPERATIONS MANUAL.
0.1 SAFETY PRECAUTIONS
- Never use the equipment in explosive atmospheres or with explosive materials.
- Never use the equipment with flammable material without first taking the required
safety precautions.
- Operate the equipment by following the instructions contained in this
MAINTENANCE & OPERATIONS MANUAL before doing an installation.
- Never turn on the temperature controller power circuit when the safety guards are
open.
- Do not use the temperature controller for tasks other than those it is designed for i.e
to control the temperature of bands or wires for industrial-grade sealing. Contact our
engineering department for information regarding specific applications.
- Do not deliver electrical power to the temperature controller if the protective cover has
been removed for special servicing on the electronic system.
- Employ qualified and well-trained personnel familiar with the technology used, to
install and use the equipment.
- Grounding the thermoregulator by yellow-green cable connected to the predisposed
screw and by 4 fixing screw.
- Use bands or wires having an adequate positive temperature coefficient ( > 1 x 10E-
3)
- When the machine is running under normal conditions, make sure the heat sink of the
controller does not exceed 60°C . If this happens, increase heat sink ventilation or
contact our engineering department.
