After the clothes have been loaded and the desired water
temperature and cycle selected, pressing
button causes the cycle to begin.
When the button is pressed, the spin speed will be
reduced from high to low during the regular cycle.
High Heat Half/Heat Button
When this button is pressed, the half heat dryi
perature is obtained. Release for maximum heat. Half
heat should only be used with delicate fabrics.
erator to select the wash program required
according to the type of fabric and degree of soiling.
Refer to the program chart o
Allows operator to select the temperature of the wash/
allows you to preset the drying time you
want according to your requirements which may be
"damp dry", "ready for ironing" or "d
putting away. The drying time depends largely on the
type of material (some fibers absorb more water than ot
ers), the dampness of the articles when the drying is
started and the amount of laundry. Table napkins, towels,
her thick) articles will take a longer time
to dry. After all the controls have been correctly set, the
ate as soon as you close the door.
During operation the Drying Timer will gradually return
to the "Stop" position "O". The final
drying cycle is the cooling phase. At the end of this
ing phase it will automatically switch itself off.
Towards the end of the tumble
cool drying period which lasts about 12 minutes.
The heater is off during this period, while the machine
When setting a wash/dry cycle the dryer pre
drum during the final spin on all cycles.
The cooling feature helps minimi
particularly important with synthetic fabrics. It is also
important to cool snaps, zippers, buttons and t
interior. Practice will soon tell you just how much drying
time to allow to get the effect you want.
The removable drain screen which protects the pump
from lint and foreign matter needs to be cleaned period
cally. How often will depend on your wash load, e.g.
cotton towels cause more lint to collect than nylon loads.
e door by pressing on the left hand side.
Turn drain screen counter
clockwise and pull the drain
screen out. Have a cloth or sha
llow tray under the drain
screen housing, as a small quantity of water may run out.
You may find it helpful to first set the mac
allow the unit to start, then remove the drain screen once
unit starts. This procedure reduces the amount of water
Clean the screen under running water to help remove any
lint. Replace the screen by sliding back into the housing
hin 3 minutes. Lastly turn clockwise to secure.
Under no circumstances should the drain screen be
removed while the machine is f
The detergent dispenser is designed so detergent,
additives and bleach will flush aut
Use only 1 to 2 tablespoons of powder detergent or liquid
It is divided into 4 compar
tments, for cold wash, hot
wash, detergents, additives (i.e. fabric softeners) and
At the end of the wash program, any r
will be automatically siphoned out leaving the dispenser
A small amount of water may
"C" and/or "D" at the end of the wash program. This can
easily be removed by pouring a small additional am
of water into this compartment, which allows the siphon
to operate and draw all the water into the machine.
gent dispenser drawer and housing
should be cleaned to prevent a build up of detergent and
fabric softener. This dispenser drawe
by pulling out. Rinse it under the tap, dry and replace.
