Before using the washer for the first time, wipe the inside
and outside with a damp cloth to remove any travel d
that has accumulated and we recommend operating a
cycle to rinse out your machine.
Be sure the hot and cold water fauc
Make sure that the power cord is plugged in and that the
a load of convenience we suggest
machine may be set to wash and dry autom
size sets will dry quicker and king
longer. Different types of materials may benefit from
being shaken out once the dry cycle has run long enough
(approximately 2 minutes) to allow the door to be opened.
nt the clothes are able to tumble freely to
allow the drying process to occur. Dry times of over 100
load condition that has resulted
in a loss of dry performance.
•
Use only 1 to 2 tablespoons of powder detergen
liquid equivalent. For cold/cold wash and rinse add
detergent to dispenser "A"; for all other wash cycles,
to dispenser "B". Refer to Wash Table
for other additive options.
•
Set the wash timer to regular wash. Set the water
selector to the desired wash rinse temperatures.
•
Set the heat and spin buttons to the out positions.
•
minutes (This automatically
includes a 12 minute cool down).
•
•
•
Water will begin to enter the drum and the wash cycle
will start. Wash time will be approximately 60 mi
utes, upon completion, the machine will automatically
start to dry the load. When the dryer has completely
he machine will automatically stop.
•
After washing and drying are complete the hot and
cold water faucets should be turned off and push the
ON/OFF switch. Wipe the inside off the washer door
soft cloth or sponge to remove
•
Once the machine is started in the wash cycle, for your
safety, the door is automatically locked and cannot be
opened. Attempting to open the door may break the
f for some reason the door must be
opened during the cycle, operate in the following way:
•
•
•
Press push button ON and wait until water is
•
Press push button OFF and wait at le
•
To restart go back to "Operating Steps".
On more heavily soiled wash loads a pr
to obtain a better wash. It will disperse any superficial dirt
and help loosen soil ready for the main wash.
wash, select the main wash cycle you wish to use.
Then turn the timer knob to the pre
eceding the regular cycle. If pre
detergent is required, the detergent must also be added in
compartment "A" of deterg
wash is completed the machine will automatically
perform the regular wash.
set a combined program of washing
drying, the cylinder must not be loaded with
more than the required load size state
Judge this load by the dry times achieved. Dry times of
over 100 minutes indicate an overload condi
resulted in a loss of dry performance.
