Video Loss Detection
You can set the camera so that the camera can trigger the alarm if it is disconnected or the video is lost due to
unstable network connection.
[MENU] Ö [ENTER] Ö ▼ Ö <Menu> Ö [ENTER] Ö ▼ Ö <Event> Ö ►▼ Ö <Video Loss Detection> Ö
[ENTER] Ö ▲▼◄► Ö [ENTER]
• Apply to CH : If you select <Apply to CH>, the "Apply to CH" confirmation window will appear.
After selecting channels that the settings will be applied to, click on <OK> to apply them to the selected
channels.
•
Video Loss State : Specify the use of video loss detection.
•
Alarm Out : Select an alarm output method.
` For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 66)
•
Alarm Duration : Specify the duration of the alarm output with the beep.
Alarm Out Schedule
You can set the conditions and operating hours for scheduled alarms.
[MENU] Ö [ENTER] Ö ▼ Ö <Menu> Ö [ENTER] Ö ▼ Ö <Event> Ö ►▼ Ö <Alarm Out Schedule> Ö
[ENTER] Ö ▲▼◄► Ö [ENTER]
•
Alarm Out : Sets the alarm output method.
` For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 66)
-
<ON> : Marked in green, and always generates alarm on scheduled time.
-
<OFF> : Marked in black, no alarm is generated even if an event occurs.
-
<Event Sync> : Marked in orange, generates alarm only when an event occurs.
•
Apply to All Alarm out : Applies the configured schedule to all alarms.
M
` When the alarm is generated on the scheduled time, you can stop the alarm by canceling the schedule.
English _75
● MENU SETUP
