DEFAULT SETTING
To reset the system, move to "System Management > Settings > Load Factory Default" and press the
<Initialization> button.
This returns the factory default settings.
M
` When you initialize the system without changing the <Authority Setting>, you must enter the ID and password to log into the
system after it reboots. The ID and password are "admin" and "4321", respectively.
Please change the password after you log in.
` The initial administrator ID is "admin" and the password should be set when logging in for the first time.
` Please change your password every three months to safely protect personal information and to prevent the damage of the information theft.
Please, take note that it's a user's responsibility for the security and any other problems caused by mismanaging a password.
Category Details Factory Default
System
Date/Time/Language Date/Time/Language
Date YYYY-MM-DD
Time 24 hours
Time Zone GMT
Time Sync. OFF
DST OFF
Language English
User
Admin ID admin
Permission Setup
Restricted Access
Backup/Record/Record
Stop/Search/PTZ/Remote
Alarm Out/Shutdown
Restriction on Network Access
None
Auto Log out 3 Min
Manual Input of ID OFF
System Management System Information Device Name NVR
Device
Camera Channel Setup
Video ON
Audio OFF
Camera Name CAM 01 ~ CAM
04
Storage Device HDD Alarm
Check Alarm Output Port BEEP
Duration Continuous
Replace Alarm Output Port BEEP
Duration Continuous
Remote Device
Remote Control ON
ID 00
Monitor Monitor
Event Display OFF
Display All
Multi CH SEQ Time 5 sec
Video Output VGA(1280x1024)
Display Position Setup 30
English _135
● APPENDIX
