A SERVICE OF

logo

Phone Settings
86
Phone Lock
(Menu 4.6.3)
When the Phone Lock feature is enabled, the phone
is locked and you must enter the 8-digit phone
password each time the phone is switched on.
The password is preset to “00000000” at the
factory. To change the phone password, see the
Change Password
menu (
Menu 4.6.4
) below.
Once the correct password has been entered, you
can use the phone until you switch it off.
The following options are available:
Disable
: you are not asked to enter the phone
password when you switch the phone on.
Enable
: you are required to enter the phone
password when you switch the phone on.
Change Password
(Menu 4.6.4)
The Change Password feature allows you to change
your current phone password to a new one. You
must enter the current password before you can
specify a new one.
The password is preset to “00000000” at the
factory. Once you have entered a new password,
you are asked to confirm it by entering it again.
Phone Settings
87
SIM Lock
(Menu 4.6.5)
When the SIM Lock feature is enabled, your phone
only works with the current SIM. You must enter
the SIM lock code to use a different SIM card.
Once you have entered the lock code, you are
asked to confirm it by entering it again.
To unlock the SIM, you must enter the SIM lock
code.
FDN Mode
(Menu 4.6.6)
The FDN (Fixed Dial Number) mode, if supported by
your SIM card, allows you to restrict your outgoing
calls to a limited set of phone numbers.
The following options are available:
Disable
: you can phone any number.
Enable
: you can only call phone numbers stored in
Phonebook. You must enter your PIN2.
Note
: Not all SIM cards have a PIN2. If your SIM card
does not, this menu option does not display.
Change PIN2
(Menu 4.6.7)
The Change PIN2 feature allows you to change your
current PIN2 to a new one. You must enter the
current PIN2 before you can specify a new one.
Once you have entered a new PIN2, you are asked
to confirm it by entering it again.
Note
: Not all SIM cards have a PIN2. If your SIM card
does not, this menu option does not display.