
72
Note
• Moving the camera before the beep sounds, after pressing the shutter
release button, could result in a blurred image.
Note
• S mode works only when the flash is disabled from firing.
• Enable the keep settings to save the S mode setting. See “Keep
Settings” (p.104).
Using Auto Bracket
This function takes three continuous frames: one each at the set exposure and at -
0.5EV and +0.5EV. This feature makes it possible to obtain correct exposure under
difficult conditions.
Mount the camera on a tripod or level surface to prevent the camera from moving.
q Set the MODE dial to [ ] and then press
the MENU button.
The Recording menu will appear.
Note
• Press the MENU button to cancel the
operation.
w Press the up or down button to
turn AUTO BRACKET to ON.
Press the ENTER button to select ON when in
OFF and then press the MENU button.
e Press the release button to take the
picture.
When the release button is pressed, three
frames will be taken at the set exposure of –
0.5EV, 0, + 0.5EV.
How To Cancel Auto Bracket
Follow the above procedures and select OFF in step e.
How To Cancel the S Mode
Follow the above procedures and select [OFF] in step e.
SOFT MODE :OFF
S MODE :OFF
AUTO BRACKET :ON
BACK:MENU SEL.:ENTER