108
Restoring the Setting
Select [0 SEC] in step e above.
MENU
[
SET UP
]
LCD CONFIRMATION : 1SEC
LCD SETTING : ON
INITIALIZE SETTING
PASSWORD : OFF
SEQUENTIAL FILE NO:ON
DISPLAY POWER :OFF
SEL.:ENTER
MENU
[
SET UP
]
LCD CONFIRMATION : 3SEC
LCD SETTING : ON
INITIALIZE SETTING
PASSWORD : OFF
SEQUENTIAL FILE NO:ON
DISPLAY POWER :OFF
SEL.:ENTER
How To Cancel the Setting
Follow the above procedures and select the other video system in step e .
Note
• When setting to PAL, this camera cannot be used as a monitor for the
video printer, etc.
• The LCD monitor would appear blank when the video cable is connected
to video gear.
Changing LCD Confirmation
When you press the shutter release button to take a picture, the shot image appears
on the LCD monitor, accompanied by a beep, before it is recorded. You can select the
image confirmation time from among 0 second, 1 second, 2 seconds, and 3 seconds.
q Set the mode dial to [ ].
The SETUP menu will open.
Note
• To cancel the operation, turn the mode
dial.
w Press the or button to select [LCD
CONFIRMATION].
e Press the ENTER button and select the
image check time (0 sec., 1 sec., 2 sec., 3
sec.).
To end setting, rotate the Mode dial and switch
to another mode.
Note
• Images are not displayed when the
image confirmation time is set to 0 sec.
The images are recorded immediately
after the photograph is taken.
