10
7. Set the console assembly face down on a soft
s
urface to avoid scratching the console assem-
bly. Hold the Right Handrail (33), which has a
large hole in one side, near the console assem-
bly.
Next, insert the console wire and the tie into the
large hole in the side of the Right Handrail (33).
Using needlenose pliers, pull the console wire
out of the hole near the bracket on the Right
Handrail.
Then, set the Right Handrail (33) on the console
assembly. Make sure that no wires are
pinched. Start an M5 x 16mm Screw (85) with
an M5 Star Washer (7) into the Right Handrail,
and then start two M4.2 x 19mm Screws (10)
into the Right Handrail. Tighten the M5 x 16mm
Screw and then tighten the two M4.2 x 19mm
Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the
console assembly in the same way. Note:
There are no wires on the left side.
8. Remove the plastic ties from the Right Handrail (33)
and the Left Handrail (not shown). If necessary,
press the Cage Nuts (105) back into place. With the
help of a second person, hold the console assem-
bly near the Right Upright (54).
Connect the Wire Harness (39) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Next, insert the connectors and
the excess wire downward into the Right Upright
(54). Then, remove the wire tie from the Wire
Harness.
8
54
39
39
33
Wire
Tie
105
Console
Wire
Console
Wire
7
Console
Wire
Large
Hole
33
Bracket
85
7
10
Tie
Console
Assembly
Console
Assembly
