Physical Controls 29
E-EQ-VX3XRG-G VX3X Reference Guide
Physical Controls
Power Button
Note: Refer to the section titled “Power Modes” for information relating to the power states of
the mobile device.
The power button is located above the ESC key on the keypad. After power is connected, the
Power button must be pressed to turn the device on.
Figure 2-2 Location of the Power (PWR) Button
Quickly tapping the Power button places the device immediately in Suspend mode. Quickly
tapping the Power button again, or touching the screen, immediately returns the device from
Suspend.
Restart Sequence
Tap Start | Run, then type warmboot in the textbox and press Enter. If the touchscreen is not
accepting taps or needs recalibration, press <Ctrl>+<Esc> to force the Start Menu to appear.
When the Windows desktop is displayed or an application begins, the power on (or reboot)
sequence is complete. If any changes to the settings had been saved previously, they are restored
on reboot.
Note: To reset to factory default values, please refer to Chapter 3 “System Configuration”
section titled “Utilities”.
