BAC-10000 Series 13 Operation Guide, Rev. J
System Setup
SYSTEM
SYSTEM ENABLE:
OCC OVRIDE (HRS): 1.0
INACTIVITY (SECS): 60
DISPLAY BLANKING: NO
AUTO
To adjust the system conguration values, such as
system enable (auto, o, heat, or cool), occupancy
override time, and display inactivity time-out:
1. Up/Down to move among entries.
2. Enter to select.
3. Up/Down to increment/decrement value.
Occupancy Override on this menu is the amount of
time (in hours) a manual change in the setpoint (via
the Up and Down buons) will be allowed to over-
ride the scheduled setpoint. When the time is set to
0, the override state will last until the next schedule
change.
When Display Blanking is enabled (Y), the display
turns o at the same time the backlight goes o
(aer reset, initial power-up, or time-out). When any
buon is pressed, the display will reappear until the
time-out is reached again.
The menu/display/backlight time-out (seconds
since the last buon is pushed) is set in Inactivity.
Access to the Main Menu, setpoint adjust, and
System/Occupancy/Fan override have a default
password level of User. This level can be changed for
each function to None, Operator, or Administrator
through this screen. Passwords are set in the (Ad-
vanced) Passwords menu. See (Advanced) Security
Levels and Passwords on page 9.
Trend Viewer
TREND VIEWER
1:
2: SPACE HUMIDITY 27
3: FAN 19
4: COOL 1 18
5: COOL 2 21
6:
7:
SPACE TEMP 34
TL #1 SPACE TEMP
APR11 1:27PM, 70.3
APR11 2:27PM, 71.3
APR11 3:27PM, 71.6
APR11 4:27PM, 71.8
APR11 5:27PM, 76.3
APR11 6:27PM, 81.2
APR11 7:27PM, 82.3
To view trend log buers, press:
1. Up/Down to move among entries.
2. Enter to select.
Trend logs are set up in the (Advanced) Trend Logs
menus (see page 10).
Setpoints
SETPOINTS
COOL SETPT:
HEAT SETPT: 67° F
COOL SETBACK: 80° F
HEAT SETBACK: 64° F
MIN SETPT DIFF: 2° F
DEADBAND: 2° F
DEHUM SETPT: 60 % RH
74° F
In the Setpoints menu, deadband, setbacks, and
setpoints for various values are set. (The room
temperature setpoint can also be manually changed
from the Home menu.)
To adjust the setpoints, press:
1. Up/Down to move among entries.
2. Enter to select.
3. Up/Down to increment/decrement value.
