■ 3des-cbc
■ aes192-cbc
■ aes256-cbc
■ rijndael-cbc@lysator.liu.se
■ aes128-ctr
■ aes192-ctr
■ aes256-ctr
connection-rate-filter
■ [no] ip access-list connection-rate-filter
Congure a connection-rate-lter Access Control List.
Next Available Option:
■ name -- Specify name of Access Control List to configure. (ASCII-STR) (p. 304)
default
■ ip ssh port default
Specify that the daemon should listen on the default TCP port (22).
default-gateway
■ [no] ip default-gateway
Usage: [no] ip default-gateway [IP-ADDR]
Description: Congure the IPv4 default gateway address, which will be
used when routing is not enabled on the switch. The IP-ADDR
must be specied if the command is not preceded by 'no'.
Preceding the command with 'no' deletes the default gateway
address.The 'no' form of this command does not take
effect on default gateway address obtained via dhcp.
Next Available Option:
■ ipaddr -- IPv4 address of the default gateway. (IP-ADDR) (p. 302)
dhcp
■ ip timep dhcp
Use DHCP to acquire Timep server address.
Next Available Option:
■ interval < 1 to 9999 > -- Specify how often (in minutes) the switch tries to get the current time.(p.
301)
dhcp-bootp
■ ip address dhcp-bootp
Congure the interface to use DHCP/Bootp server to acquire parameters.
297© 2009 Hewlett-Packard Development Company, L.P.
ipCommand Line Interface Reference Guide
