QGE 100 • Software Configuration and Control 44
Using the Special Context menu
The Special Context pop-up menu contains commands that you can select to send to
the source computer during a mouse and keyboard control session. (You can display this
menu only during a control session.)
Figure 32. Special Context Pop-up Menu
To use the Special Context menu:
1. Press the key combination specified on the Mouse & Keyboard Options window (by
default, this is <Ctrl> + <F2>). The Special Context menu pops up and a mouse
pointer appears on the Viewer window.
2. Move the mouse pointer to the desired menu option and click the command to
issue it to the source computer, or click End Keyboard And Mouse to end the control
session.
To close the Special Context menu, press <Esc> on your viewing computer keyboard.
Multicast Error Logging
Using either the QGE 100 Viewer or Administrator, you can set up the QGE to log
error conditions that occur while the encoder is operating in multicast mode. When
logging is enabled, the number of recent errors (since last check) and total errors (since
logging began) are recorded in the Multicast Errors column of the QGE 100 List on the
Administrator main window. This log can be used for trouble-shooting.
To set up error logging via either software program:
1. From the Tools menu, select Logging. The Logging Options window opens.
Figure 33. Logging Options Window
2. Select the Enable Multicast Error Logging check box.
3. In the Logging Interval field, enter the number of seconds (1 through 9) that will
elapse between log entries. (The default is 9.)
4. Click OK.
