7-6 Sending Faxes Chapter 7
Sending Methods
This section describes the methods and advantages of the two main sending methods:
Memory sending and Manual sending via the handset.
Memory Sending
Memory sending is a quick and easy way to send a document. As the first page of a
multipage document is being scanned into the MultiPASS’ memory, the unit begins
calling the other party and transmitting the information even as the remaining pages are
being scanned.
Since the MultiPASS is multitasking, you can even scan a document into memory while
performing other tasks.
The MultiPASS has enough memory to store up to approximately 416 pages* (fewer if
the document contains many graphics or particularly dense text).
Follow this procedure for memory sending:
1 Open the document tray.
2 Adjust the document feed lever for the
document you are loading. (1 p. 4-2)
3 Prepare the document and load it, face
down, in the ADF. (1 p. 4-4)
• For colour sending, press Colour/B&W to
(Currently used memory)
turn on its light. (1 p. 7-2)
• To adjust the resolution and contrast,
1 pp. 7-3, 7-4.
(Standby to scan)
• You may be unable to use memory sending if
the percentage shown in the LCD is close to
100%. Use manual sending via the handset
instead. (1 p. 7-7)
4 Dial the other party’s fax number.
Ex:
• For dialling methods, 1 p. 7-5.
• If you enter the wrong number, press Stop,
then enter the correct number.
• If you must first dial a digit to get an outside
line (“9”, for example), add a pause after that
digit by pressing R/Pause.
TEL= 9p7654321
DOCUMENT READY
MEMORY USED 0%
*Based on Canon FAX Standard Chart No. 1, standard mode.
