Filter
Top Products
Door Arm Hookup
Tools: Needle nose pliers
Align hole in the door arm with holes in drawbar operator bracket tabs, as shown. Insert 5/16”
x 1-1/4” clevis pin, making sure hole in clevis pin is outside of second tab of drawbar operator
bracket. Insert hairpin cotter into clevis pin hole and spread hairpin cotter to secure assembly,
as shown.
Drawbar operator
bracket tabs
5/16”x 1-1/4”
Clevis pin
Cotter
pin
Spread cotter pin
Clevis pin
Door arm
Drawbar
operator bracket
Inside Lock
Tools: Power drill, 7/16” Socket driver, Tape measure
Install the inside lock on the second section of the door. Secure the lock to the section with (4)
1/4”-20 x 11/16” self drilling screws. Square the lock assembly with the door section, and align
with the square hole in the vertical track. The inside lock should be spaced approximately 1/8”
away from the section edge.
IMPORTANT: INSIDE LOCK(S) MUST BE REMOVED OR MADE INOPERATIVE IN THE UNLOCKED
POSITION IF AN OPERATOR IS INSTALLED ON THIS DOOR.
Second section 1/8”
Inside lock
End cap
(4) 1/4”-20 x 11/16”
Self drilling screws
Square hole in
vertical track
Pull Down Rope
Tools: Power drill, 1/8” Drill bit, Tape measure
WARNING WARNING
DO NOT INSTALL PULL DOWN ROPE ON DOORS WITH OPERATORS. CHILDREN
MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR FATAL INJURY.
Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the
right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the
no. 6 screw eye and to the bottom corner bracket, as shown.
Bottom corner
bracket
Pull down
rope
No. 6 Screw eye
Pull down
rope
48” to 50”
From floor
15
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,
refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Optional Installation