Filter
Top Products
6. LEVEL ADJUSTMENT
@@
Set the scale on a stable and level surface.
Level the scale by turning the adjusting legs so that the air bubble comes to
the center circle. For example, in the case of the condition shown in the left
figure, turn the adjusting legs (1) and (2) in the direction shown so that the
Correct Incorrect
bubble comes to the center of the circle.
Adjusting Legs
f
Level
7. CLEANING THE PRINT HEAD
If the print head is dirty, clear printing is not performed. It is recommended to clean the head with thermal
head cleaner everyday, before starting operation by following procedure:
thermal head cleaner.
Then set the label, and push down the print
head.
NOTE:
Do not damage the print head when
cleaning.
Head
al Head Cleaner
-7-