Toshiba EM1-31064 Scale User Manual


 
17-1
17. CLEANING THE PRINT HEAD
EM1-31064
17. CLEANING THE PRINT HEAD
17. CLEANING THE PRINT HEAD
If the print head is dirty, printing will not be clear. The print head should be cleaned with a print head
cleaner everyday before use, according to the following procedure:
1. Open the label cover and remove the label cassette. (See page 9-1)
2. Clean the print head element with the print head cleaner.
3. Clean the print head element with the print head cleaner.
NOTE: Be careful not to damage the print head when cleaning.
4. If any label paste is found on the cutter, wipe off the paste with alcohol.
After removing the label cutter, reattach it using the following procedure.
1. Install an unloaded label cassette on the scale.
2. Install the label cutter, aligning the cutter notches with the screw holes.
3. Secure the cutter with the screw (FL-3x6) so the bottom of the cutter is 0.5~0.8 mm above
the peel-off plate.
Print Head
Print Head Cleaner
Element
Screw (FL-3x6)
Clearance
0.5~0.8 mm
Peel-off Plate
Label Cutter
Screw (FL-3x6)
Head Holder
Label Cutter
WARNING!
Since there is a cutter at the paper outlet, be careful not to injure your fingers when
cleaning the print head and cutter.
NOTE: If the cutter is scratching labels during printing, increase the clearance between the cutter
and peel-off plate.