Toshiba EM1-31064 Scale User Manual


 
14-1
14. OPERATING PROCEDURES
EM1-31064
NOTES BEFORE STARTING OPERATION
14. OPERATING PROCEDURES
NOTES BEFORE STARTING OPERATION
(1) Insert the power plug into the AC outlet and turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the POWER key.
(3) Do not move the unit while it is in operation. Should it become necessary to move it at any
time, turn the power switch to the OFF position and be sure to reajust the level indicator after
relocating the scale.
(4) Should a power failure occur during operation, remove the commodity from the platter and
insert the power plug into an AC outlet again when power is restored.
(5) If the scale is used with an unrated power source, inaccurate scaling or other errors may
occur.
(6) If the zero point has shifted during scaling, and no tare is displayed, adjust the zero point by
depressing the ZERO key.
(7) Check the date of the scale before operation every day.
(8) Make a test print before operation every day.
Press the TEST key, and the test label is issued.
How to access the REG., M.DOWN, or REWRAP menu
The following display is the REG. menu display. When this display is shown after pressing the POWER
key, you can start the REG. operation right away.
To access a menu from other menus, press the ESC. key to show the Main menu and enter the menu
No. When the M.DOWN and REWRAP menus are protected, enter the menu No. and then the
password.
NOTE: If nothing is printed or is issued after a printed label in batch mode, refer to Section 11.11 and
press the SET NEXT key.
<REG.> MANU. WEIGH
ENTER THE PLU #
UNIT/$
P
lb
0.000
TOTAL $
000000
<Menu>
0. PROG. 5. REPORT
1. REG 6. RESET
2. MARK DOWN 7.
3. REWRAP 8.
4. SECURITY 9.