Filter
Top Products
32
930317 Rev. C
IX. SET UP, ADJUSTMENT & USE
H. SEAT FRAME
A 12º angle-adjustment is standard on all
Quickie P300 wheelchairs.
1. Adjustment
a) Remove the front securing bolt (A) on
the side of the backrest hinge plate.
b) Loosen the lower rear bolt (B)
c) Set at desired angle.There are four holes
( in 4º increments) to choose from.
d) Reinstall the front bolt and tighten
both bolts securely.
Note: Adjustment on both sides of the wheel-
chair must be exactly equal.
I. FOLDING BACKREST
Quickie P300 wheelchairs are shipped
with backrest in folded position.
1. Upright Positioning
a) Lift backrest to upright position so
that latch handles (C) lock into place.
b) Backrest is ready for use.
2. Folding Backrest
a) Lift and turn backrest latch handles
(C) outward.
b) Fold backrest forward.
CAUTION: Backrest latches must be
locked into place before operating
wheelchair.
J. SEAT DEPTH
The seat depth can be adjusted in one
inch increments.
1. Seat Frame Adjustment
a) To adjust, remove the two bolts (A) from
each side of the backrest pivot plate.
b)
Reposition the backr
est to the
desired position.
c) Replace and retighten bolts on each
side of the backrest pivot plate.
Note: Adjustment on both sides
of the wheelchair must be exactly equal.
A
B
C
A