Filter
Top Products
28
930317 Rev. C
IX. SET UP, ADJUSTMENT & USE
Note on Torque Setting: A torque setting is
the optimum tightening which should be made
on a particular fastener.A torque wrench
which measures in./lbs. Should be used when
tightening fasteners on Quickie wheelchairs.
Unless otherwise noted, use a torque setting of
120 in./lbs.When setting up this wheelchair.
A. BATTERY REMOVAL AND
INSTALLATION
To remove the batteries for transporting
or servicing:
1. Remove Batteries
a) Unplug the battery connectors located
on the controller plate for both
battery boxes.
b) Push battery cables under battery
tray lever (A).
c) Lift tray lever (A) up.
d) Fold tailgate (B) down.
e) Slide batteries under motors, away
from chair.
f) Lift up batteries by lifting up on
battery lifting straps (C ).
Batteries my weigh up to 55 lbs. Care
must be taken to avoid injury when lifting.
2. Installing Batteries
a) Lift tray lever (A) up, lower tailgate (B).
b) Slide batteries onto tailgate. Cables
should be positioned to the rear
of batteries.
c) Slide batteries all the way forward on
battery tray.
d) Lift up on tailgate.
e) Pull tray lever down.
f) Plug battery cables into connectors.
B
C
A
B
A