Filter
Top Products
931150 Rev. A
Troubleshooting / Maintenance
11
English
TROUBLESHOOTING
MAINTENANCE
• Check all of the tires for wear or damage.
• Check the brakes approximately every 4 weeks to make sure that they are working
properly and easy to use.
• All of the joints that are critical to safe using your wheelchair safely are self-locking.
Please check every three months to make sure that all bolts are secure (See the page
on torque). Nylock nuts should only be used once and should be replaced after each
use.
• Please use only mild household cleansers when your wheelchair is dirty. Use only
soap and water when cleaning the seat upholstery.
• If your wheelchair should ever get wet, please dry it after use.
Depending on the frequency and type of use, we recommend taking your wheelchair to your
authorized dealer every 6 months to have it inspected by trained personnel.
CAUTION– Sand and sea water (or salt in the winter) can damage the bearings of the front and rear
wheels. Clean the wheelchair thoroughly after exposure.
Problem
Wheelchair pulls to one side.
Casters begin to wobble.
Wheelchair /Cross-tube assembly does not snap
into position in the seat saddle.
Wheelchair is difficult to fold up.
Wheelchiar squeaks and rattles.
Wheelchair begins to wobble.
Solution
1. Make sure wheel turns easily (bearings, axle).
2. Make sure both casters are making proper
contact with the ground.
1. Make sure all bolts are secure; tighten if
necessary (see the page on torque).
2. Make sure both casters are making proper
contact with the ground.
1. Chair is still new, i.e., the seat or backrest
upholstery is still very stiff. This will improve
with continued use.
1. Screws of the cross-tube brackets are too tight.
1. Make sure bolts are secure; tighten if
necessary (see the page on torque).
2. Apply small amount of lubrication to spots
where moveable parts come in contact with
one another.
1.
Check to see if rear wheels are adjusted
differently.