Filter
Top Products
- 48 -
Press ENTER or F1:
Stop motore se in moto per … (Stop motor after …)
The following two messages concern the osmosis pump
motor condition. Set = 0 to exclude this mode; if the value
is not 0, the motor stops running after having run
continuously for the set period, then starts again.
After two seconds, the system displays:>>>>>>>>>>>>>>
Press ENTER or F1:
If the conductivity value remains below set value, no alarm
trips, otherwise an alarm displays.>>>>>>>>>>>>>>>>>>>
Press ENTER or F1:
Set number of pulses per litre for the product flow
meter.>>>>>>>>>>>>>>>>>>>>>>>>>>
Press ENTER or F1:
Set number of pulses per litre for the waste flow
meter.>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Press ENTER or F1:
Set minimum production below which a fault is
reported.>>>>>>>>>>>>>>>>>>>>>>>>>>>>