20
Storing, recalling, and erasing measurement data
21
Storing, recalling, and erasing measurement data/3 Zones of 40 Memory
Storing, recalling, and erasing
measurement data
•
Storing data
*After each measurement, the systolic and diastolic rates, pulse
rate and the time & date will be automatically stored. The memo-
ry holds data for the latest 80 measurements in each of 3 memory
zones. If more than 80 measurements are entered, the memory will
automatically clear out the oldest data.
Recalling data
*Press the " " or " " button to select the memory zone.
*Press the "MEM" button to get your stored memory data. If there
is no data in the memory nothing will appear.
*If there is data in the memory, the first reading will be
an average of the last three recorded set of measure-
ments (systolic and diastolic pressure and pulse rate).
*Press the "MEM" button again and the latest recorded
set of measurements will appear along with the record-
ing time and date.
*Press the "
" button to read the next set of stored data. The data
displayed starts with the most recent reading and continues back-
wards to the oldest.
*If your memory readings are out of range of your preset personal
Alert levels. They will flash or show SMILING FACE symbol as
explained on the previous page.
*No Irregular Heartbeat Detector Record will be stored in memory.
•
3 Zones of 80 Memory
When you take a measurement, the monitor automatically stores it in
memory space number one. As you continue to take measurements, the
monitor will push the previous measurement back one space. In other
words, the value in space one will always be the most recent blood pres-
sure measurement taken.
Your monitor features a 3 party memory capability or 3 "zones" - each
zone stores 80 measurements each for a total capacity of 240 measure-
ments. This feature is useful for a user to track their blood pressure
throughout the various periods of the day: morning, afternoon, and night.
Press the
" " button to toggle between memory zone No.1, 2, and 3.
Once you select a zone that you want to view the measurements in,
press the "MEM" button once to view the most recent measurement
along with the time and date that it was taken. Press the "MEM" button
again in succession and you will see all of the measurements registered
to that zone. You can then press the
" " button to switch to the next
zone to view measurements. The monitor will automatically power off
after about one minute of inactivity.
*When taking measurements, be sure and select the correct zone
number using the SET button so that the measurement is registered
to the appropriate zone.
Storing, recalling, and erasing
measurement data
Erasing data
*Press "MEM" into Memory mode.
*Press and hold on "MODE" button and then press "
" button, the
pre-set Personal Alert Level and all measurement data will be erased.
*To confirm the data has been erased, press the "MEM" button and no
data should appear.
•