Filter
Top Products
HOW TO USE THE POLISHING CLOTH
Always clean jewelry in the Jewelry Spa before polishing, doing so will
remove contaminants that may be abrasive and will attach to the polishing
cloth. Bypassing the cleaning steps can result in scratching the highly polished
surface of the jewelry during polishing.
1. Lay the polishing cloth down on a flat surface
with the white inner cloth facing up. The inner
side of the cloth contains a polishing
compound. Then with smooth even strokes
slide the jewelry back and forth. This will help
in brightening the high spots on the jewelry
where it tends to become dulled by wear.
2. Next buff to a high luster with the outer cloth.
The outer cloth does not contain polishing
compound. Then rinse the jewelry in the Steam
Clean cycle of The Jewelry Spa only. The
steam will rinse off the black residue that is left
from the polishing cloth. This will clean the
jewelry of polishing compound and eliminate
black rings that could otherwise appear
around your finger, wrist or neck.
3. Tip: If, after a first cleaning in the Jewelry
Spa, you find that soap or paint etc. has
hardened in the holes behind the gemstones,
or in hard to get crevasses in the back side of
a ring, or the link of a chain, you need to help
break up the deposit. Use a round tooth pick,
dip it in the cleaning bath until it becomes
soaked and somewhat soft, then press it on the
counter until you see what looks like bristles on
a small paint brush. This is perfect for getting
into the areas of dirt deposits. Then repeat the
cleaning process in the Jewelry Spa.
10