Filter
Top Products
STEAM CLEANING JEWELRY
1. Using the tweezers supplied with your Jewelry Spa remove the jewelry item with
the tweezers and holding the supplied strainer in the other hand, carefully place the
jewelry into the strainer.
2. Press the Steam button, then position the jewelry under the steam
nozzle as shown in the picture. A stream of distilled water will
be pumped into the dual port steam generator system. As it
is doing this you will see some spurts of dry steam vapor,
this is normal. Approximtely 10-15 seconds after pressing
the Steam button it will deliver a burst of wet steam to
sterilize and rinse the jewelry item. The pump will
automatically shut itself off after 15 seconds. Use the
tweezers to help direct the steam into the areas where it is
needed to push out residual dirt and grime from the
soaking/electric cleaning process.
NOTE: If there is still dirt and grime remaining in grooves you can repeat these steps
as many times as needed to assist removal of dirt and grime. Also if you require a burst
of steam with more pressure, when the indicator light goes out, immediately press the
Steam button again.
NOTE: Due to changes in temperature during the heating process variations may
occur in the steam burst, this is normal.
NOTE: During periods of extended use, occassional puffs of steam may occur, this is
normal.
CAUTION: Always use tweezers and strainer for handling jewelry; jewelry and steam
will be HOT.
DIFFERENT WAYS OF HOLDING JEWELRY
WHILE STEAM CLEANING
Hold diamond stud earrings, bangle bracelets or rings with your tweezers to direct
steam behind the stone to remove the soap, dirt and grime that becomes lodged in the
setting.
Use the Jewelry Cleaning Basket to help with large chains, pins, or bracelets. Use the
strainer to help with small jewelry items (eg. earrings, thin chains, charms) or anything
that you feel is not too big to fit in it.
9