Filter
Top Products
BEFORE USING FOR THE FIRST TIME
1. Carefully unpack Jewelry Spa.
2. Remove any packing materials.
3. Wipe with a soft, clean cloth or sponge.
Never immerse Housing in water or any other liquid.
STARTING UP THE JEWELRY SPA
1. Place The Jewelry Spa on a flat firm surface, preferably a countertop in
your kitchen or bathroom.
3. Make sure all loose components; Water Reservoir and Cleaning Tank
Safety Cover (11), Removable Catch Basin (8), Removable Water
Reservoir (10), and Jewelry Cleaning Basket (12) are all securely in place.
2. Plug the Jewelry Spa into 220-240V AC household electrical outlet.
4. Open Water Reservoir Safety Cover (11) and fill with
DISTILLED WATER ONLY, then close lid for
operation of jewelry cleaning. NEVER add
cleaning solution or other substances to the
water reservoir.
5. Remove Jewelry Cleaning Basket (12).
6. Fill cleaning tank with DISTILLED WATER
ONLY to the fill line on cleaning tank wall,
Approximately 1.3cm (1/2 inch) from top of tank.
7. Using the provided Measuring Scoop (14) slowly add
10 grams (2 scoops) of cleaning powder to the
cleaning tank. Slowly stir solution to help the
powder dissolve. Refer to the Cleaning Powder
label or Page 15 of this booklet for handling
instructions.
NOTE: Never add Cleaning Agent to Cleaning
Tank without adding water first. ALWAYS add
Distilled Water prior to adding Cleaning Agent.
8. Close Cleaning Tank Cover. NOTE: You can leave
Safety Cover for Cleaning Tank in open position
while heating up, if desired.
9. Press On/Off Button (1) once, the indicating
light will come on. Allow 10 to 15 minutes for
the Cleaning Tank to reach required
temperature. The Ready Light will come on
when the steamer is ready to operate.
7
4
6
9