Salton JW10 Ultrasonic Jewelry Cleaner User Manual


 
14
USER MAINTENANCE INSTRUCTIONS
This appliance requires little maintenance, it contains no user-serviceable parts. Any
servicing requiring disassembly other than instructed below must be performed by
Salton Customer Service. See last page for details. CAUTION: Always unplug
Jewelry Spa from electrical outlet when not in use and before
cleaning. Never immerse Jewelry Spa, cord or plug in water or any
other liquid.
DRAINING, CARE AND CLEANING:
CAUTION: Always allow Jewelry Spa and cleaning solution to cool down
before preparing to drain for storage.
CAUTION: When lifting machine, always lift from both sides. See Picture for
example.
1.Remove the Catch Basin (8) and Work Area as it will have water
accumulated in the sponges, use care not to spill. Drain in the sink. Next
remove the Safety Cover (11) for cleaning tank, the reservoir lid assembly
place and Jewelry Cleaning Basket. Rinse with warm water and dry with
paper towels or a soft towel. Rinse and wring out the sponges.
2.Next remove the Distilled Water Reservoir (10) from the back of the Jewelry
Spa. Use the handle and pull up gently. Pour the unused Distilled Water
back into its original container for re-use.
3.Next, carefully drain the cleaning solution from the
stainless steel tank into the sink using the built in spout
of the cleaning tank as shown in the picture. Note: It
is safe to pour the used cleaning solution down
household sink drains. After draining, fill the tank with
warm water and drain again. Dry with paper towels or
a soft towel. After the above steps have been
completed, run tap water down the drain for 10
seconds to clear the drainage line.
4.Rinse the tweezers and small strainer. Dry with paper
towels or a soft towel.
5.When cleaning has been completed, thoroughly wash hands and any other
areas of the skin exposed to the cleaning solution.