Filter
Top Products
7
ENGLISH
CLEANING THE MASK BETWEEN
PATIENTS
The mask system (excluding the swivel and short air tubing) is
validated for multipatient use. Clinicians should refer to the Masks
Disinfection/Sterilisation Guide for details.
To clean the headgear between patients use the method
described in the previous section “Cleaning the Mask in the
Home”.
REASSEMBLING THE MASK
1 Attach the forehead pads to the forehead support. To do this,
place the forehead pad plugs into the two round holes of the
forehead support. Then push firmly behind the base of the
forehead pad plugs (Fig. D-1) until the tip of the plug is
securely seated over the hole. The base of the forehead pad
plug should be flush against the forehead support.
2 Reconnect the forehead support to the mask frame
(Fig. D-2). Depress the tab and move the forehead support
into one of the four slot positions.
3 Fit the cushion clip into the groove of the mask cushion.
Ensure the cut outs under the cushion clip latches are aligned
with the blocks in the groove of the mask cushion.
Fit the top section first (Fig. D-3), then work your way
around, inserting the cushion clip into the mask cushion.
Ensure that the cushion clip does not pinch any part of the
mask cushion (Fig. D-4). The cushion clip should fit snugly
inside the groove of the mask cushion.
4 Attach the cushion assembly to the mask frame. To do this,
align the two side latches on the cushion clip to the top two
holes on the mask frame (Fig. D-5). Then push the cushion
60880r2.book Page 7 Thursday, October 20, 2005 11:55 AM