Filter
Top Products
EC Series EN-7
4 OPERATIONS
4.1 Switching the Unit On and Off
The power switch is located underneath the right-hand side of the scale. Push the
switch to the “I” position to turn the scale on, and to the “O” position to turn the
scale off. Allow 15-30 minutes for the scale to warm up before use.
NOTE: Make sure the weighing pan is empty before turning the scale on.
4.2 Manual Tare
Tare is indicated by the
QQ
QQ
QT annunciator.
Place the container on the weighing
pan (ex. 100g), then press TARE.
“tARE” will be displayed momentarily
before the weight is tared.
------.
0.0.
Weight g
100.0.
tArE
0.0.
Piece Weight g/pc
0..
------.
0..
Count pcs
0..
With an empty pan:
Press PT, “PrEtA” will flash on the
display. Enter a numeric value (ex.
200g), then press PT. The Pre-set
Tare will be displayed as a negative
value (no weight on the pan).
200.0.
-200.0.
Weight g
0.0.
PrEtAPrEtA
PrEtAPrEtA
PrEtA
0..
Piece Weight g/pc
PrEtAPrEtA
PrEtAPrEtA
PrEtA
------.
------.
Count pcs
------.
4.3 Pre-set Tare
Pre-set Tare is a known tare value entered via the numeric keypad
Pre-set Tare is indicated by the
QQ
QQ
QT annunciator.
With an existing weight on the pan
(ex. 250g):
Press PT, “PrEtA” will flash on the
display. Enter a numeric value
(ex. 200g), then press PT.
The Net weight will be displayed.
When the weight is removed from the
pan, the negative weight displayed
is the Pre-set Tare value.
NOTE: To clear the Tare or Pre-set Tare value, press TARE with the pan empty.
0.0.
200.0.
Weight g
250.0.
PrEtAPrEtA
PrEtAPrEtA
PrEtA
PrEtAPrEtA
PrEtAPrEtA
PrEtA
Piece Weight g/pc
0..
------.
------.
Count pcs
0..
50.0.
-200.0.
0..
0..
0..
------.
3 EC-textEN.pmd 8/9/2005, 1:41 PM7