30 www.pridemobility.com Litestream XF
IV. COMFORT ADJUSTMENTS
Positioning Belt
Your wheelchair may be equipped with a positioning
belt that can be adjusted for operator comfort. See fig-
ure 43. The positioning belt is designed to support the
operator so that he/she does not slide down or forward
in the seat. The positioning belt is not designed for use
as a restraining device in a motor vehicle.
WARNING! If your wheelchair is
equipped with a transit securement
system, the positioning belt should
only be adjusted by a Quantum Rehab
Provider or a qualified technician.
To install the positioning belt:
1. Remove and discard the screws on both the left and
right back canes. See figure 43.
NOTE: If your wheelchair is equipped with dual-post
armrests, the existing back cane screws must be
replaced with screws that are 2 in. (5 cm) long to
properly install the positioning belt.
2. Insert the longer screws through the positioning
belt and then through the back canes on each side of
the wheelchair seat. See figure 43.
3. Tighten both screws.
4. Install the positioning belt onto the bracket and pull
until the positioning belt snaps into place.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the
belt into the plastic housing on the opposite side
until you hear a click. See figure 44.
2. Pull the excess strap attached to the metal tab until
it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Push the button mechanism on the plastic housing.
MANDATORY! Make sure the
positioning belt is properly secured to
the wheelchair and is adjusted for
operator comfort before each use.
MANDATORY! Inspect the positioning
belt for loose parts or damage,
including tears, worn spots, bent
hardware, or damaged latch
mechanisms, before each use of the
wheelchair. If you discover a problem,
contact your Quantum Rehab Provider
for maintenance and repair.
Figure 44. Positioning Belt Adjustment
Figure 43. Positioning Belt Installation