Filter
Top Products
34
www.pridemobility.com
Revo
ASSEMBLY
1. Position the front and rear sections of your scooter. See figure 19.
2. Align the locking brackets of the front section with the corresponding pegs on the front of the rear section.
3. Holding the seat post, slowly pivot the rear section forward until the locking brackets are fully connected onto the
rear pegs. See figures 18 and 19.
4. Raise the tiller.
5. Secure the toggle latch. See figure 17B.
! Lower the toggle latch buckle.
! Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness.
7. Reinstall the battery packs and engage both battery pack locks. Always replace the right battery pack first.
8. Replace the seat.
9. Unlock the tiller by rotating the tiller lock knob 90 degrees counterclockwise.
WARNING! Position the front-to-rear harness so it will not become pinched between the
frame halves when pivoting the rear section forward.
VII. DISASSEMBLY AND ASSEMBLY
WARNING! Before getting onto your scooter always check that the tiller lock knob is in the
unlocked position. Attempting to ride your scooter with the tiller lock knob in the locked
position can result in personal injury.