Filter
Top Products
32
www.pridemobility.com
Revo
VII. DISASSEMBLY AND ASSEMBLY
Figure 15. Battery Pack Removal/Installation
Figure 16. Front-To-Rear Harness
LEFT BATTERY PACK LOCK
LEFT BATTERY PACK
#
Figure 14. Tiller Lock Knob
SHOWN IN
UNLOCKED
POSITION
Figure 13. Scooter Components
REAR
SECTION
FRONT
SECTION
BATTERY PACKS
SEAT
NOTE: When DISASSEMBLING the scooter, al-
ways remove the LEFT battery pack first. When
ASSEMBLING the scooter, always install the
RIGHT battery pack first.
DISASSEMBLY
You can disassemble the scooter into seven pieces: the
seat, the front section, the rear section, the rear shroud,
the basket, and the batteries. See figure 13. No tools
are required to disassemble or assemble your scooter,
but keep in mind that the disassembled sections of the
scooter take up more floor space than the assembled
unit. Always disassemble or assemble your scooter on
a level, dry surface with sufficient room for you to work
and move around your scooter—about 5 feet (1.5
meters) in all directions. Remember that some scooter
components are heavy and you may need assistance
when lifting them.
1. Remove the key and ensure that the manual free-
wheel lever is in the drive position.
2. Lock the tiller in place by positioning it forward,
then pushing the tiller lock knob inward and turning
it clockwise 90 degrees. See figure 14.
3. Remove the seat by pulling up on the seat rotation
lever, rotating the seat one-eighth of a turn, and lifting
the seat up and off of the scooter.
4. Disengage the left battery pack lock by pulling it
outward from the scooter. See figure 15.
5. Remove the left battery pack by lifting it straight up
and away from the scooter. See figure 15.
6. Repeat steps 4 and 5 for the right battery pack.
7. Unplug the front-to-rear harness. See figure 16.
WARNING! Do not lift beyond your
physical capability. Ask for assistance
when necessary while disassembling
or assembling your scooter.