Filter
Top Products
32 www.pridemobility.com Sundancer
ASSEMBLY
1. Place the manual freewheel lever in the drive (up) position.
2. Position the front and rear sections of your scooter as shown in figure 17.
WARNING! Position the front-to-rear harness cable so it will not become pinched between
the frame halves when pivoting the rear section forward.
3. Align the lower slots on the rear of the front section with the corresponding pegs on the front of the rear section.
See figure 18.
4. Gently lift up on the seat post on the rear section of your scooter, so the rear section pivots into place.
5. Secure the front and rear sections with the ball detent pin.
6. Raise the tiller
7. Plug the front-to-rear harness into the mating plug found on the rear electronics module.
8. Put the batteries in place and plug the black and white 2-pin battery harnesses into the rear electronics module.
9. Reconnect the battery straps.
10. Gently place the rear shroud over the seat post.
11. Lower the shroud into place.
12. Carefully lift the seat and slide the seat platform post (on the seat bottom) into the seat pedestal.
13. Rotate the seat until it locks into place.
I X . DISASSEMBLY AND ASSEMBLY
Figure 17. Frame Positioning
FRONT-TO REAR HARNESS
CABLE
Figure 18. Connecting The Frame Halves