Filter
Top Products
30 www.pridemobility.com Sundancer
DISASSEMBLY
You can disassemble the scooter into seven pieces: the
seat, the front section, the rear section, the rear shroud,
the basket, and the batteries. No tools are required to
disassemble or assemble your scooter, but keep in mind
that the disassembled sections of the scooter take up
more floor space than the assembled unit. Always
disassemble or assemble your scooter on a level, dry
surface with sufficient room for you to work and move
around your scooterabout 5 feet in all directions.
Remember that some scooter components are heavy and
you may need assistance when lifting them.
WARNING! Lifting weight beyond
your physical capability may result
in personal injury. Ask for assistance
when necessary while disassembling
or assembling your scooter.
1. Place the manual freewheel lever in the drive (up)
position.
2. Coil the charger power cord and store it for future
use.
3. Pull up on the seat lock lever and lift the seat straight
up and off the scooter. See figure 11.
4. Gently pull the shroud away from the frame and lift it
off of the scooter. See figure 12.
5. Disconnect the battery straps.
6. Unplug both black and white 2-pin battery harnesses.
See figure 13.
7. Unplug the front-to-rear harness that connects the
tiller console to the rear electronics module. See figure
14.
WARNING! Failure to unplug both
battery harnesses and the front-to-
rear harness prior to separating the
front and rear sections could result
in permanent damage to the scooter.
I X . DISASSEMBLY AND ASSEMBLY
Figure 12. Rear Shroud Removal
ç
ç
Figure 11. Seat Removal
SEAT LOCK LEVER
Figure 13. Battery Harnesses
BATTERY HARNESSES
BATTERY STRAPS