Filter
Top Products
Quantum 500 www.quantumrehab.com 25
Figure 18. Adjusting Controller Position (Mounting
Block Shown)
SETSCREWS
V. COMFORT ADJUSTMENTS
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Foot Platform Angle
You can adjust the angle of the foot platform with a hex key.
See figure 15.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew counterclockwise to raise the front of
the foot platform.
3. Turn the setscrew clockwise to lower the front of the
foot platform.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Turn the rear shroud fasteners counterclockwise one-
quarter turn. See figure 6.
3. Remove the rear shroud.
4. Unplug the controller connector(s) from the power base.
5. Cut the wire tie(s) securing the controller cable to the armrest.
6. On a contour seat, flip up the armrest and loosen the
setscrew. See figure 17. On the standard seat, loosen
the setscrews in the mounting block. See figure 18.
7. Slide the controller out of the armrest.
8. On a contour seat, loosen the setscrew in the other arm
rest. On the standard seat, loosen the mounting screws in the
mounting block, move the mounting block to the other arm
rest, and tighten the mounting screws. See figure 18.
9. Place the controller in the other armrest.
10. Tighten the setscrew(s) to secure the controller.
11. Use a wire tie to secure the controller cable to the armrest.
11. Plug the controller connector(s) into the power base.
12. Reinstall the rear shroud and tighten the fasteners.
Figure 17. Underside of Armrest
SETSCREW
MOUNTING
SCREWS
MOUNTING
BLOCK