Filter
Top Products
34 www.pridemobility.com Hurricane
VIII. BASIC TROUBLESHOOTING
What if all the systems on my PMV seem to be “dead”?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your PMV.”
Make certain that both T-handle battery harnesses are firmly connected to the rear section and to the
battery terminals. See VII. “Disassembly and Assembly.”
Make sure that the front-to-rear harness is firmly connected to the rear section. See VII. “Disassembly
and Assembly.”
Be sure the power down timer feature has not been activated. See V. “Operation.”
Check the 3-amp fuse located on the lower portion of the tiller console. See IX. “Care and Mainte-
nance” for fuse replacement.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your PMV are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed
below develops.
NOTE: Your PMV will not run unless the flash code condition is resolved and the PMV has been turned
off, then turned back on.
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and can
no longer hold a charge.
FLASH CODE CONDITION SOLUTION
(1)
Battery voltage is too low to operate the
PMV.
Check connections between batteries and
controller.
(2)
Motor disconnected. Check all connections to the motor.
(3)
Motor wiring fault. Call your authorized Pride Provider for assis-
tance.
(6)
PMV will not operate because the
charger is attached or the power seat
switch was pressed while the PMV was
in motion.
Unplug the charger power cord from the off-
board charger port. Restart your PMV by
turning your PMV off, then back on.
(7)
Throttle potentiometer fault.
Contact your authorized Pride Provider for
assistance.
(8)
Internal controller fault.
Contact your authorized Pride Provider for
assistance.
(9)
Brake fault—your PMV was left in
freewheel mode.
Turn the PMV key to the “off” position, then
push the manual freewheel lever to the drive
position, and restart your PMV.
(10 )
Excess voltage to controller. Check all connections between the batteries
and the controller. If condition persists, contact
your authorized Pride Provider for assistance.