Filter
Top Products
38 www.pridemobility.com Jet 10/Rev H/Feb03
To inspect or replace the motor brushes:
1. Remove the seat and body shroud. See VII. Disassembly.
2. Unscrew the motor brush caps. See figure 27.
3. Remove the brushes.
4. Inspect for wear. See figure 28.
5. Replace brushes, if necessary. Contact your authorized Pride provider for replacement brushes.
X. CARE AND MAINTENANCE
Figure 27. Motor
MOTOR BRUSH CAPS
Figure 28. Motor Brushes
NEW MOTOR BRUSH
WORN MOTOR
BRUSHES
The electric motors that power your Jet 10 use carbon brushes. These brushes may become susceptible to wear
over a long period of time. The motor brushes are the two contacts located inside the motor assembly that supply
power to the motor. They are designed to provide several thousand hours of operation. However, if the brushes
become dirty with carbon deposits or wear out, the motor will run poorly or not at all. We recommend that your
authorized Pride provider inspect the brushes every six months, or sooner if your Jet 10 runs poorly.
CAUTION! If inspection determines excessive wear on the brushes, they must be replaced or
motor damage will result. Failure to maintain the brushes could void the warranty.
MOTOR BRUSHES
11. Connect the wire marked (+) to the closest positive (red) battery terminal.
12. Connect the wire marked (-) to the closest negative (black) battery terminal on the other battery.
13. Connect one circuit breaker harness to the empty positive terminal of one battery, and connect the other circuit
breaker harness to the empty negative terminal of the other battery.
14. Retighten all nuts.
15. Replace the shroud and seat.
WHEN TO SEE YOUR AUTHORIZED PRIDE PROVIDER FOR SERVICE
The following symptoms could indicate a serious problem with your Jet 10. If necessary, contact your authorized
Pride provider. When calling, have the model number, serial number, nature of the problem, and the trouble code,
if available.
WARNING! Make sure you tighten the fasteners so that the connections are secure.